Change Your IP address
Step 1. Click on “Start” in the bottom left hand corner of screen
Step 2. Click on “Run”
Step 3. Type in “cmd” and hit ok You should now be at an MSDOS prompt screen.
Step 4. Type “ipconfig /release” just like that, and hit “enter”
Step 5. Type “exit” and leave the prompt
Step 6. Right-click on “Network Places” or “My Network Places” on your desktop.
Step 7. Click on “properties”
You should now be on a screen with something titled “Local Area Connection”, or something close to that, and, if you have a network hooked up, all of your other networks.
Step 8. Right click on “Local Area Connection” and click “properties”
Step 2. Click on “Run”
Step 3. Type in “cmd” and hit ok You should now be at an MSDOS prompt screen.
Step 4. Type “ipconfig /release” just like that, and hit “enter”
Step 5. Type “exit” and leave the prompt
Step 6. Right-click on “Network Places” or “My Network Places” on your desktop.
Step 7. Click on “properties”
You should now be on a screen with something titled “Local Area Connection”, or something close to that, and, if you have a network hooked up, all of your other networks.
Step 8. Right click on “Local Area Connection” and click “properties”
Step 9. Double-click on the “Internet Protocol (TCP/IP)” from the list under the “General” tab
Step 10. Click on “Use the following IP address” under the “General” tab
Step 11. Create an IP address (It doesn’t matter what it is. I just type 1 and 2 until i fill the area up).
Step 12. Press “Tab” and it should automatically fill in the “Subnet Mask” section with default numbers.
Step 13. Hit the “Ok” button here
Step 14. Hit the “Ok” button again You should now be back to the “Local Area Connection” screen.
Step 15. Right-click back on “Local Area Connection” and go to properties again.
Step 16. Go back to the “TCP/IP” settings
Step 17. This time, select “Obtain an IP address automatically” tongue.gif
Step 18. Hit “Ok”
Step 19. Hit “Ok” again
Step 10. Click on “Use the following IP address” under the “General” tab
Step 11. Create an IP address (It doesn’t matter what it is. I just type 1 and 2 until i fill the area up).
Step 12. Press “Tab” and it should automatically fill in the “Subnet Mask” section with default numbers.
Step 13. Hit the “Ok” button here
Step 14. Hit the “Ok” button again You should now be back to the “Local Area Connection” screen.
Step 15. Right-click back on “Local Area Connection” and go to properties again.
Step 16. Go back to the “TCP/IP” settings
Step 17. This time, select “Obtain an IP address automatically” tongue.gif
Step 18. Hit “Ok”
Step 19. Hit “Ok” again
Step 20. You now have a new IP address
With a little practice, you can easily get this process down to 15 seconds.
This comment has been removed by the author.
ReplyDelete